Ball Shaped End Caps

August 17, 2018

Share this Flipbook
Facebook
Twitter
Email
LinkedIn

In this paper, general ball shaped end-caps are studied and illustrated. Different ball shaped end-caps were tested and measured for a variety of applications. For example, a 2.2 mm diameter ball shaped end-cap was manufactured on the end of the output LMA fiber and tested with a 1.7 kW fiber laser system.

Previous Flipbook

Fiber Cladding Mode Stripper

Presented and characterized are an optimized cladding mode stripper design that increases the cladding ligh...

Next Flipbook

Annular Heating of Optical Fiber with a CO2 Laser Using Reflective Axicon Elements

By offsetting the light structure, precise localized zone heating and annealing of specific areas at a fibe...

Most Recent Flipbooks

OPGW and OHGW Bonding Assembly Selection

Ball Shaped End Caps

Previous Flipbook

Next Flipbook

Most Recent Flipbooks

Selecting the best bonding assembly configuration is dependent on proximity from the termination or suspension hardware to the support structure, terrain and wind conditions and tower hardware.

This white paper will introduce the larger categories of splice loss estimation methods and applications to better explain in context how the Fujikura's 41S splicer estimation technique performs.

This white paper explores the options electric utilities have to bring fiber deeper into their networks and AFL's FOLLOW THE POWER™ approach.

Cost study: Compared to a traditional splicer-cleaver combination, a Bluetooth-enabled splicer/cleaver combination produce a 76% cost of ownership reduction and weeks of time reclaimed.

Demonstration of low attenuation metal-coated optical fiber and cable capable of withstanding temperatures up to 500°C. Performance will be validated by using a DTS instrument to measure temperature.

This paper will demonstrate a metal-coated fiber capable of withstanding temperatures up to 500°C.

This paper will further explore some of the advantages of using ADSS cable as opposed to a strand and lash fiber cable for aerial electric utility applications.

This paper presents results obtained by using the high thermal expansion coefficient of the ZBLAN fiber to encapsulate a smaller SiO2 fiber.

In this paper we present an all fiber end pumped 7x1 pump combiner fabricated by CO2 laser splicing system.

Presented and characterized are an optimized cladding mode stripper design that increases the cladding light loss with a minimal device length and manufacturing time.

By offsetting the light structure, precise localized zone heating and annealing of specific areas at a fiber’s surface can be achieved as well.

DWDM allows you to add additional capacity without replacing your existing CWDM infrastructure and with minimal—if any—service interruption.

The new ultra-density fiber optic cable technology, called Wrapping Tube Cable (WTC), utilizes a new optical fiber ribbon arrangement technology called SpiderWeb Ribbon (SWR®).

Alternate cable stub options and how they could be used to lower overall FTTx deployment costs to provide rural Americans with access to reliable, high-bandwidth internet.

The new method for alignment of asymmetric polarization-maintaining (PM) fibers improves alignment accuracy for PM fibers with asymmetric stress applying parts.

Advanced fiber designs will further improve component performance, enhance reliability, simplify manufacturing processes and reduce material costs.

FTTx PONs present unique installation and maintenance troubleshooting challenges.

Field-installable connectors provide a convenient method for terminating fiber optic cable at remote job site locations.

The recently released Fujikura PCS-100 is a novel stripping tool for removing polyimide coating from optical fibers.

A new method for alignment of polarization-maintaining (PM) fibers has been developed that solves alignment problems with low-contrast PM fibers.